Z-Axis wobble.

Updated on December 30, 2019 in Hardware

Unfollow Follow

Madalam 2 0 on October 26, 2019

My Uniz slash’s Z -axis is wobbling. I can see the wobble even while moving the build platform manually. The troubleshooting guide says to return the machine to the factory. Is there any way to solve this issue. I’m fairly acquainted with various tools and electronics, so can try and repair if possible. Anyone else faced the same issue?

Liked by

uniz after sale 0 0 on October 28, 2019

Hi, you can send your question to support@uniz.com. Someone will solve the problem for you.

Liked by

Franc 0 0 on December 30, 2019

Hopefully you already solved your problem, but the wobbling in general is not a big issue. I think that you meant that the lead screw is wobbling, right?!? As long as linear rails are OK, the screw itself doesn’t cause much troubles.

Liked by

Click here to start your discussion

YOUR PREVIEW

0 0