Any reason and good solution for this problem?
I am using zWAX resin.
Only sticking a thin layer on building platform and vat surface
Updated on May 3, 2018 in
Support & Troubleshooting
I was able to finally get some successful prints. The reason I was not getting any print was I did not know I could change the parameters. As this picture desktop shows that the parameter setting option is all blocked by another window so I did not know. This is another unthoughtful way of writing the firmware program.
I never had any experience in 3D printing. UNIZ is my first 3D printer.
I am finally getting some good product quality outputs.
Lost wax burn out casting is not too bad with zWax but still do not like this clear yellow resin because it is hard to inspect due to its reflective and transparent presentation.
- Liked by
YOUR PREVIEW
0
0