Bubble level and straight level

Updated on May 12, 2020 in Hardware

Unfollow Follow

Stephan 3 0 on April 27, 2020

Hello,

I’m setting up my new Slash 2.

When I use the bubble level to align the printer the vat will not be parallel to ground. The resin in the vat will not be parallel to theMax Level line.

When I us a level to align the printer relative to the vat, the bubble level will be off center.

Is this a fault or is the vat to be slanted when the printer is aligned ?

Thanks for any insight

Stephan

Liked by

Fernando 0 0 on May 10, 2020

Hi I have the same problem, in fact with the bubble level in center, the fluid level in the VAT is with a big inclination compared to the fluid level line on the VAT.

Please someone to confirm which level to use? bubble level or line level of VAT