control button not working

Updated on December 25, 2018 in Support & Troubleshooting
1 on December 20, 2018

I’ve just set up my new Slash pro udp installed the latest software and connected to slash via ethernet and can see the wifi icon but can’t connect by wifi only ethernet so far almost fine then when I set a print off when the build platform goes into the tank the connection drops and the printer hangs, any ideas.

Also the control button will not function

 

 
  • Liked by
Reply
0 on December 25, 2018

The priority of ethernet is higher than wifi. If you want to connect wifi, please unplug ethernet first.

For hanging issue, may I know what’s your firmware version? 

Have you tried reboot printer and see whether it hangs again?

Please also double check dual power supply and ensure both power supply are connected firmly.

  • Liked by
Reply
Cancel
Loading more replies