@

“Cracking” sound on the first layers (slash plus)

Updated on December 25, 2018 in Hardware
Unfollow
3 on December 23, 2018

Hello,

I use a Slash plus and at the first or the first two layers the Slash makes “cracking” sounds when the building platform goes up from the resin tank.

Then when it goes up at the second or third layer it is just a “plop”.

In this Video you can hear the sounds.

https://youtu.be/KRlichB9pJY

Is this “cracking” Sound normal and if not, how can i fix it?

Sebastian

Cancel
 
  • Liked by
Reply
Hanson 0 on December 25, 2018

Hi Sebastian, the video cannot be played.

Did you print a large area in the first layer? You can set motor speed of the first layer to “Low” to reduce this sound.

  • Liked by
Reply
Cancel
Cancel
Steen 0 on December 25, 2018

I believe that it is the resin that sticks between the tank and platform. It also did the cracking sound on my 1x1cm cube. It sometimes does this and sometimes dont, im not sure why tho.

  • Liked by
Reply
Cancel
Cancel
Sebastian 0 on December 25, 2018

Hello Hanson,

now you can see the Video, it was on private, my fault.

I think Steen is right, it does not depend on the Surface size, it sounds like the first layer stick to much on the Tank an the Motor has some Problem with that.

And because of the “plop”, the support answer me:

“Our engineer advise you to plug the air pump out ,there will not have the “plop”. and recently ,we will launch the newest software version ,will repair this problem, if the printed model is bigger, there will be the plop”

Sebastian

  • Liked by
Reply
Cancel
Cancel
Loading more replies

© 2018 UNIZ TECHNOLOGY LLC. All rights reserved.