different ways to print???

Updated on December 30, 2019 in General Discussion
1 on December 23, 2019

is there something i need to do differently after a successful print other then clean and store all materials. I have had 2 small successful prints but now on my 3rd print it will not allow me to print. There is a connection, resin and file accepted by Uniz software. do i have to do something different now to get the slash ol working again?? why will it not work after 2 prints(under 1.5 ml per print), i even tried to reprint old print and it also will not allow me to do anything. 

 
  • Liked by
Reply
0 on December 30, 2019

Hey Freddy. You should be more specific to get any help. So, what went wrong? What messages do yo get if any from software. Any unusual thing happened with your printer? In addition Uniz claims that they have 24/7 support now. USE IT!!!

  • Liked by
Reply
Cancel
Loading more replies