hanging problem on the board

Updated on October 4, 2018 in Support & Troubleshooting

Unfollow Follow

Geoffrey 11 0 on September 28, 2018

Hello , i have an hanging problem on the board , i try lot of thing but not to sand the board , have you any tips to help me ?
Thank you in advance

Liked by

Houmin 0 0 on October 1, 2018

Can you be more specific about the problem or post a picture about the problem?

Thanks.

Liked by

Geoffrey 0 0 on October 1, 2018

Yes no problem , it’s a problem with dental resin , we have this hanging problem on the board when we change setup of precision , in 100µm , no problem but in 50µm there is a lot of problems , i post the picture immediatly

Liked by

Houmin 0 0 on October 2, 2018

Can you please post the slice setting for 50um? Thanks.

Liked by

Geoffrey 0 0 on October 2, 2018

It’s for dental resin , dentifix , this slice settings were given to us by our supplier

Liked by

Geoffrey 0 0 on October 2, 2018

It’s for two kinds of resin

Liked by

Houmin 0 0 on October 2, 2018

How much exposure time did you set for the 100um print? Judging from the result, the burn-in layers were fine, but the following layers are under-exposed, I would suggest increasing the exposure time by 50%.

Liked by

Geoffrey 0 0 on October 4, 2018

For 100µm , i use this exposure time

Liked by

Geoffrey 1 0 on October 4, 2018

This parameters are given by our reseller for this resin , you think they’re wrong ?

Houmin 0 on October 4, 2018

Would you please try to check the bottom of Resin Tank, perform a cleaning process, and see if there is any debris left on the film from previous prints?

https://www.uniz.com/us_en/page/support_slash_printing_and_maintance/