How to calibrate resin liquid level sensor

Updated on September 10, 2018 in Software
4 on March 21, 2018

When the resin liquid level is high, but the resin pump doesn’t stop, or when the resin liquid level is very low, the resin pump does not start, what should be done?

You maybe need to calibrate the sensor to have a try.Refer following:

Calibration of resin liquid level–MOD

 
  • Liked by
Reply
0 on March 21, 2018

I would love to do this if i had my resin tanks and resin….

 

  • Liked by
Reply
Cancel
2 on September 8, 2018

How do you set LOW THRESHOLD VALUE, since there is no CAL button for it and the window must be closed before you can click on the FILL button again to add more resin? When more resin has been added in the VAT tank, and you open the level setting again, you can read this high threshold, but now it says it can’t register it since the other values are empty again. Endless circular loop logic.

Sorry but the flmsy PDF doesn’t help. Please explain further.

on September 8, 2018

I considered pouring the resin in the vat directly from the bottle. Still cannot calibrate. I tried with 2mm of resin, then much more (almost one entire bottle poured in the vat). When I click on the read button for a given level of resin, the software constantly displays the following values in random order:

0
239
-3145537

So I cannot callibrate. Is my level sensor faulty? (it is correctly mounted in the rear of the vat with its filling tube)

BTW It takes ages to pump the resin back in the bottle (much longer than to pump in the vat).

on September 10, 2018

For the LOW THRESHOLD VALUE, just click the read button, don’t need to click the cal button. When you shift the difference level resin, you don’t need to close the window.

Show more replies
  • Liked by
Reply
Cancel
Loading more replies