Is there any reason why the inscription in these models wont print. 
I have usually print with the base (where the writing is ) against the plate but i have also printed in different ways and even when the base isnt againstthe writing it still wont print the inscription
Any ideas?
Thanks Bret
You can try to print by changing the Angle of the model.
Hello, you click on the slice, then click on the display slice, switch to 3D and see if the word exists.
I didn’t understand much why you did this show, proofreading-services.org/online.php because it cannot help a beginner how can I make the necessary settings.
