Offset Error Correction

Updated 5 days ago in Ideas & Suggestions
4 on January 12, 2020

Because of diffusion of UV light through the resin the outside perimeter is always bigger and inside perimeter (hole) is always smaller. An Offset error correction would come handy here! Best slicers DO HAVE this feature!

Curing “overshooting” due to diffusion:

 

Smaller holes and larger outside perimeters:

 
  • Liked by
Reply
0 on January 13, 2020

To clarify… Offset correction is basically scaling down on outer perimeters and scaling up on inner perimeters!!

  • Liked by
Reply
Cancel
2 on January 13, 2020

I think you should email our support@uniz.com to ask for a solution to your issue

5 days ago

Please DON’T!!! Please no BS!! We really, really don’t deserve that. 

BTW. At least on paper this time UNIZ did a good job. There is a setting (see picture) that address exactly this! WELL DONE!

5 days ago

I yet have to try it though…

Show more replies
  • Liked by
Reply
Cancel
Loading more replies