Slash Ol problems

Updated on March 28, 2019 in General Discussion
1 on March 24, 2019

I’ve not owed my Slash long and already having lots of problems.

I’ve noticed it doesn’t like staying connected to my pc but the problem seems to be on the software side because if I click off the WiFi tab on the uniz program and then click it again it comes back online for 5 seconds where I can control the printer again before it goes off.

This is a big problem for me because I cannot connect through Ethernet.

Other problems are lcd screen bending that can be sorted by stripping down some of the machine.

The udp mode feels like a scam as well.

After 2 hours of pump use it stopped working and I had to replace it because uniz failed to reply to me. I’ve wasted over 4 litres of resin with this printer and at £150 per 500ml it’s not cheap. I really with I bought another form 2 now ?

I’ve read people having many faults and It’s very hard for me to get 1 print that doesn’t fail. Uniz should take them off the market and fix the problems rather than carrying in selling a flawed product. If your reading this uniz either send me out one that works or give me a refund!

  • Liked by
0 on March 28, 2019

Hi James,

Sorry for the inconvenience caused. You can feedback your issue to Our support team will try our best to resolve your problem.

  • Liked by
Loading more replies