Why do you print it like that?Can you print it in flat to the platform?

because we try to place the maximum of models on the platform, and that he can not print it so?

In my experience the build platform peels away from the vat unevenly and too quickly for the first 30mm or so. Try setting the first 20-30mm of layers @2.5 seconds with low motor speed and a rise height of 8mm. Then 2 seconds for the rest. If this shows improvement but not perfect increase exposure by increments of 0.2 seconds depending on where the print broke away from the platform and test again.From StevieRich

That will be helpful for you.

What options should I set for this print?

You are a very experienced person with slash.