[img width='' height='']http://forum.uniz.com/wp-content/uploads/2018/10/20181011_103444.jpg[/img]
[img width='' height='']http://forum.uniz.com/wp-content/uploads/2018/10/20181011_145622.jpg[/img]
[img width='' height='']http://forum.uniz.com/wp-content/uploads/2018/10/20181013_153317.jpg[/img]
[img width='' height='']http://forum.uniz.com/wp-content/uploads/2018/10/20181015_163207.jpg[/img]
[img width='' height='']http://forum.uniz.com/wp-content/uploads/2018/10/20181015_175215.jpg
[/img][img width='' height='']http://forum.uniz.com/wp-content/uploads/2018/10/20181015_181237.jpg[/img]
Solid flatware still not very good printing. The resin is not getting drained but trapped on large solid surface. I should have set up the flatware slanted way instead of flat.
Drill holes and the hollowed back with grilled covers came out nice because it had very good drainage.
I put the motor speed slow to make sure it has enough time to drain before the next light hits.
.025mm with 7sec exposure, took 01:40 to print.
I am still figuring out the optimum burn out cycle for zWax resin. So far it has to burn at least 2:30 hours at 1385fh.
i am having horrible burnout with this material. any tips for best investment powder for the resin to stop breakage or how to get rid of exess ash in the mold? thanks!
You need to log in to upload images from your computer.
You can also sign in by :