Zwax correct Parameters

Updated on June 29, 2018 in Support & Troubleshooting
2 on June 7, 2018

Hi everybody,

I would like to know the correct parameters for Harden the resin in the oven UV and to burn the Zwax please.

 
  • Liked by
Reply
0 on June 28, 2018

I try to set longer exposure time like 11sec for 0.05mm layer which makes longer time consuming but yield more clean and solid output with less distortion. UV 2 to 3min and 8 to 12-hour burnout schedule will do good casting. 

  • Liked by
Reply
Cancel
0 on June 29, 2018

Hi, I will try your settings, because mine are 4 seconds of exposure time to 0.025 mm and the results are not good.

thank you.

  • Liked by
Reply
Cancel
Loading more replies