The resin level sensor shows the same value, 14947, regardless of the liquid level. I have tried it with the connector in both orientations when plugging it in. I have tried calibration, etc. with no success.
resin sensor shows same level, 14947, regardless of liquid level.
Updated on October 10, 2018 in
Software
Slash OL (running in the trial period) with firmware 3.4
3.4? or 4.3? I think it should be 4.3, I recommend you calibrate it by USB connection. BTW, you can refer below linkhttp://forum.uniz.com/thread/how-to-calibrate-resin-liquid-level-sensor/
- Liked by
YOUR PREVIEW
0
0