Resin Sensor does not seem to work

Updated on June 21, 2019 in Support & Troubleshooting

Unfollow Follow

EXCIT3D_ 3 0 on September 20, 2018

Hello,

so after we recieved our SLASH PRO UDP we did some successful prints without the resin sensor.
But now, for bigger prints, we would like to use it. I do remember, that I saw something in the manual regarding the sensor, but I can’t find it anymore. So the problem is, that it seems like the sensor is not detecting the resin level.

Does the sensor need to be set up? Thanks for your help.
Ben

Cancel

Liked by

Uniz Support 0 0 on September 21, 2018

Usually, the liquid level sensor is calibrated when the printer leaves the factory. If it is found that the collected signal is not accurate, it needs to be calibrated. Refer below linkhttp://forum.uniz.com/thread/how-to-calibrate-resin-liquid-level-sensor/

BTW, if you want to use the auto pump, you should turn on the function on the control panel.

Liked by

James 0 0 on November 3, 2018

The resin level sensor on my printer only appeared to work correctly after a print or two.

There is absolutely no way I trust it enough to use the auto pump feature though. First time it just continued to pump forever.

Liked by

aymeric 0 0 on June 21, 2019

Hello its the samething for me. But when a click on Icon calibration resin level. There is no popup Screen thats open. Plz tell us thanks

Liked by

Click here to start your discussion

YOUR PREVIEW

0 0